CM400 - Single Wire Continuous Monitor, One Operator Only
- Eliminate the need to test ESD wrist straps prior to the shift and stop failures of ground equipment during the work day
- Continuously checks the functioning of one single wire wrist strap
- Easy to use: Simply plug in the wrist strap and the device begins monitoring
- Audible and visual alarms indicate an issue with your ESD equipment
- It is a fixed resistor system and there is no calibration needed.
The CM400 single wire constant monitor for one wrist strap only ensures your workstation is ESD protected.
The CM400 single wire constant monitor continuously checks the total grounding system, including the operator, the wristband and the coil cord, and alarms if there is any issues. The monitor is compatible with most single wire wrist straps and coil cord sets. This is the simplest, and most cost-effective way to ensure a wrist strap is continually working. An audible alarm and light will signal a failure.
- Continuously checks the functioning of one single wire wrist strap
- Easy to use: Simply plug in the wrist strap and the device begins monitoring
- Audible and visual alarms indicate an issue with your ESD equipment
- It is a fixed resistor system and there is no calibration needed.
Why Use Constant Monitors
Since people are one of the greatest sources of static electricity and ESD, proper grounding is paramount. One of the most common ways to ground people is with a wrist strap. Ensuring that wrist straps are functional and are connected to people and ground is a continuous task. Using a constant monitor eliminates the need to test wrist straps and coil cords before, during and after shifts. They are constantly monitoring the grounding system, and will alarm if there are problems. This eliminates failures that happen after a wrist strap passes a test but fails during the work shift. The CM400 complies to ANSI ESD S20.20 standards.
Calibration
The CM400 single wire constant monitor are factory calibrated and will never need recalibration. It is a fixed resistor system and is go no go, there is no calibration needed. You can verify proper working conditions with the CM410PV  periodic verification.