Relay Controlled Power Outlet
- Use the CM-RELAY-IOT power strip with Constant Monitors to safely control AC power to your ESD protected workstation
- Relay Controlled Power Strip (2 Normally Off, 1 Normally On, 1 Always On)
- Controls power to workbenches, hand tools, and other electronic devices dependent on the Full-Time Continuous Monitor’s status
- This is an excellent addition for locations such as loud factories and large assembly floors.
- Works with model number CM330, CM1600, CM2815, CM2800 constant monitors from Transforming Technologies.
Use the CM-RELAY-IOT Relay Controlled Power strip with Constant Monitors to safely control AC power to your ESD protected workstation
Integrate the Power Strip with any relay enabled constant monitor, such as Transforming Technologies’ Ranger Pro CM1600 or SpartanMAX 330 to turn off power to your work bench, power tools and other electronic devices if the monitor signals an un-safe ESD condition.
Plug the dependent tools into the Power Strip as normal and simply connect two wires – one to ground and one to the constant monitor relay signal – to control power to the workstation.
A single logic input signal controls one high-current SPDT AC relay. This one relay trigger signal switches three AC outlets simultaneously using a single-pole double-throw relay. One outlet normally is on. Two are normally off. A fourth outlet is unswitched. All outlets are protect-ed against surges and overloads. The relay can also be controlled by an AC input voltage of 12 to 120VAC. No changes or jumpers are re-quired.
Works with model number CM330, CM1600, CM2815, CM2800 constant monitors from Transforming Technologies.